Together with the guitar, this was the first of my modified Audiovox design to be completed. Solid poplar bodies, stained to look like walnut, with single bindings. Each pickguard used an entire sheet of material; only these two got the pearl treatment, the rest got much less expensive masonite pickguards.
Except for being a guitar and a bass, these two are nearly identical - the same humbuckers and electronics, knobs, etc. The scales are 30" and 25.5".
The "Fenderbird" is a mash-up of a Gibson Thunderbird body and a Fender neck. You'd expect such a thing to be a mutt, but this mutt comes with a great pedigree - invented by no less than John Entwistle of The Who.
I took a drive over to Harbor Freight - purveyor of fine {sarcasm} Chinese tools & hardware - and picked up this little drill press. With a coupon, it cost me just over fifty bucks. This is not what I would call a good drill press, in fact, it is pretty crappy. The base and the table are stamped, not forged, and small. The quill travel is a measly two inches, parts that should be steel are aluminum, parts that should be aluminum are plastic, vibration is excessive, and the 3/8" chuck has a disconcerting wobble to it. I knew all that when I bought it, and I never would have if I did not already have a much better one, or at least a decent one. What I wanted from this drill press is small size and lightweight, so I can add it to my inside workstation, and not have to leave the heat/ac to go drill a hole in the garage. This press weighs well under 40 pounds and doesn't take up too much space on my inside workbench. My 'good' drill press is not something you'd want to move around a lot.
Questions or Inquiries?
Just want to say Hello? Sign the .