Luthiery Laboratories

Doing Things Wrong

Audiovox Solid-Body Bass (1/3)

Together with the guitar, this was the first of my modified Audiovox design to be completed. Solid poplar bodies, stained to look like walnut, with single bindings. Each pickguard used an entire sheet of material; only these two got the pearl treatment, the rest got much less expensive masonite pickguards.

image

Except for being a guitar and a bass, these two are nearly identical - the same humbuckers and electronics, knobs, etc. The scales are 30" and 25.5".

 1 2 3  

All Built, Audiovox, Basses, Body - Built, Body - Poplar, Body - Solid, Electronics - Passive, Gibson, Neck - Built, Projects, Short-Scale Basses,

Comments on Audiovox Solid-Body Bass

Questions or Inquiries?

Just want to say Hello? Sign the .

Submit a Comment

Your email address will not be published. Required fields are marked *


Click image to replace if unable to read.

Enter the digits from the image above, except for the last one:

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Mitre Box

image

I made this little mitre box. It goes in 5-degree steps from 0 to 45 degrees. I don't know if that will actually be useful, but it gives me something to play with. Although I made it with the saw shown, I would use it with a fret saw, which is narrower and runs in the slots nicely. The important thing is not that the angles are super accurate, but that they are repeatable. I think.

More: Mitre Box ...

Hard to believe this is WordPress.

If you are in the EU, leave this website immediately before the cookie police arrest you. Who is that knocking at your door? Too late.

This website is 100% AI-free

72 // 43646 // 319

Printed from luthierylabs.com