Luthiery Laboratories

Doing Things Wrong

Uke-Scale Basses

Basses built with a uke scale length of 21 inches.

Uke-Scale Bass

Audiovox Uke Bass

This bass is a 21" scale, with a piezo saddle mounted in an adjustable bridge. The soundhole is just for looks. The strings are metal-wound Kalas. The fretboard is cut out of the ugliest piece of wood I ever received. For such a small neck, I managed to cut around most of the ugly, and the result isn't half bad.

More: Audiovox Uke Bass ...

Stratocaster Uke Bass

21" neck, adjustable bridge with piezo saddle, active electronics. EBay body. Now has metal-wound strings.

More: Stratocaster Uke Bass ...

Working Metals

Bending steel is not that difficult. You can make a pretty tight bend up to 90 degrees in up to 1/8″ material simply by clamping it in a vise and hammering it over. To go beyond 90 degrees, say 180 degrees for a truss rod, first bend it to 90 degrees, then heat the elbow and finish the bend. Heat the bend point until it glows orange. For smaller (guitar-sized) materials, a common hand-held propane torch should be adequate. After bending, quench the part quick in water, like a blacksmith in a western movie. You can hold a small part under the faucet. That will restore the strength of the material.

More: Working Metals ...

Hard to believe this is WordPress.

If you are in the EU, leave this website immediately before the cookie police arrest you. Who is that knocking at your door? Too late.

This website is 100% AI-free

51 // 510626 // 145

Printed from luthierylabs.com