Danelectro Longhorn Guitar (1/2)
Another early build for me - 2010, a reissue Danelectro neck on a built body. The finish is pearl automotive acrylic lacquer. The pickguard is actually clear with a piece of paper under it.
Danelectro Companion Guitar
Danelectro Longhorn Guitar
Danelectro Pro-1 Guitar
Danelectro Pro-1 Bass
Danelectro Silvertone 1443 Bass
Danelectro Silvertone U-1 Guitar
Danelectro Silvertone 1448 Guitar
Danelectro Silvertone 1457 Rescue Guitar
Danelectro Silvertone 1457 Guitar
Danelectro '63 Guitar
Danelectro "Super-63" Guitar
Danelectro Silvertone 1450 Guitar
Danelectro Silvertone 1472 Amplifier
Danelectro '67 Hornet Guitar
Danelectro Longhorn Bass
Danelectro is my favorite type of guitar, simply for the genius of their unorthodox, inexpensive, yet highly effective designs. I love the tone of old-growth masonite. If you are looking for details, the Pro-1 Bass is the most complete build documentation.
More: Danelectro Projects ...
Masonite is the classic Danelectro body material. Vintage Danelectros are Masonite over a poplar core, modern ones substitute plywood for poplar, which is actually better and cheaper. Masonite is available in 1/8" and 3/16" thicknesses. For luthiery, 1/8" is preferable, but 3/16" can also be used, especially if a slightly thicker and heavier body is desired.
More: Masonite ...
Tolex side binding is something that is particular to Danelectros. I love it. There are many good points to using Tolex side binding:
More: Danelectro Tolex Body Binding ...
The classic Danelectro bridge is a study in simplicity. A chromed brass plate*, drilled and notched, with a rosewood sliver for a saddle.
More: Danelectro Bridges ...
When two pickups are wired in series, the output of one is connected to the ground of the other. The outputs are directly additive, there is no loading effect as with parallel wiring. You get noticeably more output, and usually a much fuller sound. Two pickups may be wired in series with a standard [ON-OFF-ON] switch, available at any hardware store.
More: Series Wiring ...
I took a drive over to Harbor Freight - purveyor of fine {sarcasm} Chinese tools & hardware - and picked up this little drill press. With a coupon, it cost me just over fifty bucks. This is not what I would call a good drill press, in fact, it is pretty crappy. The base and the table are stamped, not forged, and small. The quill travel is a measly two inches, parts that should be steel are aluminum, parts that should be aluminum are plastic, vibration is excessive, and the 3/8" chuck has a disconcerting wobble to it. I knew all that when I bought it, and I never would have if I did not already have a much better one, or at least a decent one. What I wanted from this drill press is small size and lightweight, so I can add it to my inside workstation, and not have to leave the heat/ac to go drill a hole in the garage. This press weighs well under 40 pounds and doesn't take up too much space on my inside workbench. My 'good' drill press is not something you'd want to move around a lot.
More: Drill Press ...
Questions or Inquiries?
Just want to say Hello? Sign the .