Doing Things Wrong

Website Improvements

... consistency is the hobgoblin of little minds ...

-- Ralph Waldo Emerson

I re-worked the default WordPress TwentySixteen theme into something far better. Not only is the display much more streamlined and compact, but the code behind it as well. The people who design these things overkill them into an unmanageable mess. Most of what I did was simply deleting miles and miles of repetitive unnecessary css spaghetti code and replacing it with just a few new lines. Most developers seem to think that more code is better. That is so wrong.

Mosrite Bass

This post needed some color. I think the new layout looks and works great on everything from my hi-rez laptop to my tablet to my phone. While I was at it, I bulked-up the menu system and then deleted it, as well as the header image. That way you get right to the meat of things, without having to scroll every page past a lot of useless eye-candy. I also started a links page. Finally, I folded my custom navigation plugin into the theme, so that it can't be accidentally disabled.

Kubicki bodies

I also did some work on these. I think everything looks great !!!


Bending steel is not that difficult. You can make a pretty tight bend up to 90 degrees in up to 1/8″ material simply by clamping it in a vise and hammering it over. To go beyond 90 degrees, say 180 degrees for a truss rod, first bend it to 90 degrees, then heat the elbow and finish the bend. Heat the bend point until it glows orange. For smaller (guitar-sized) materials, a common hand-held propane torch should be adequate. After bending, quench the part quick in water, like a blacksmith in a western movie. You can hold a small part under the faucet. That will restore the strength of the material.