I made this little mitre box. It goes in 5-degree steps from 0 to 45 degrees. I don't know if that will actually be useful, but it gives me something to play with. Although I made it with the saw shown, I would use it with a fret saw, which is narrower and runs in the slots nicely. The important thing is not that the angles are super accurate, but that they are repeatable. I think.
Not sure if I will ever use this for anything.
These are guides that you can buy or make yourself to accurately and easily make tricky cuts and routs.
More: Templates & Jigs ...
This is a Martin-style single-acting truss rod. I built it years ago and never used it, and at this point, I never will. I am breaking it up for parts, so I thought I'd post a picture first. It consists of a 10-32 threaded rod in an aluminum channel. At the fixed end, at the lower left, the rod is set in a T-nut and the end is peened (hammered) over to keep it from rotating. The adjusting end is nothing more than a washer between the nut and the channel. Both ends are secured by bending the channel over them, then the center of the channel is cut down and everything is ground to minimal dimensions. You can find detailed directions online.
More: Martin-Style Truss Rod ...
Questions or Inquiries?
Just want to say Hello? Sign the .