Uncategorized (1/6)
I was looking at that crazy Ric body, and wondering if my binding rig will get into those deep corners. Getting around that long narrow horn without wobbling might also be a problem. So I started thinking about alternatives.
More: A Better Way to do Binding? ...
After settling for two weeks, it is time to set up this baby. This bass is new territory for me in a lot of ways. One of those is the individual bridge-lets. I used up pretty much all the height adjustment. That shouldn't happen, so I took everything apart to look for the reason, and I found it, I think.
More: All Apart Now ...
All assembled and strung up with D'Addario round-wounds. The action fell into place with just a little adjusting. I set the intonation with a yardstick, which works better than you'd think. Add 3/16" for the E string, 0 for the G, and split the difference in between.
More: All Together Now ...
This wound up on the back burner for a while, but I finally got back around to it. The black stripe is 1/16" tape from the roll there, applied to the shiny under-layer. It wasn't that hard to apply, using the screw holes as guides. It's not awfully sticky, but should hold up well sandwiched between the clear pickguard and the body. You can get that tape at Hobby Lobby. I finished the pickup 'routs' with hand files.
More: At Least I Learned Something ...
The 1/2" flush-cut router bit came today. I mic'ed it, and it is just a few thousandths shy of 12.7mm. I put my old 3/8" / 9.5mm bearing on it, with a spacer I made from a tiny washer, and did a test cut. Then I swapped the bearing for 10mm and did another. These Yonico bits are nice because they color-coordinate with DeWalt tools !
More: Bindings Again, and etc ...
The two Kubicki bodies finally have all the bursted edges done. This is a dark brown, not a black, that looks very nice with the yellow of the pine, as you can see here on the Strato-vox:
More: Bursts Done ...
I reorganized the wiring section of the website. It was basically years of notes and diagrams, dumped in a pile. Better now.
More: Cleaned Up a Rat's Nest ...
This is the Ric body template I made earlier. What's the point of making a template if you only use it once? Underneath are the sections for the new body. I used about 13 feet of 2x2" lumber, under $20 at Home Depot. I arranged the pieces so the stripier faces show. I'm also extending the tongue on the template. I had a brain fart and cut it too short when I made it.
More: Radiatabacker Part I ...