Kitchen Table ~ Luthiery Laboratories

Kitchen Table

If You're Going to Build a Guitar on Your Kitchen Table …

… you don't want to ruin the table !!!

The big brown rectangle is a piece of 3/16" Masonite. This makes a very inexpensive sacrificial top. I just wiped it down with linseed oil to make it purty again; a light sanding once in a while doesn't hurt either. And when it gets too grody, throw it out and get another. It's like a giant placemat. Here, I have a placemat on top of a placemat. What does that say about me? Probably nothing very good.

Comments on Kitchen Table

Questions or Inquiries?

Just want to say Hello? Sign the .

Submit a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Working Metals

Bending steel is not that difficult. You can make a pretty tight bend up to 90 degrees in up to 1/8″ material simply by clamping it in a vise and hammering it over. To go beyond 90 degrees, say 180 degrees for a truss rod, first bend it to 90 degrees, then heat the elbow and finish the bend. Heat the bend point until it glows orange. For smaller (guitar-sized) materials, a common hand-held propane torch should be adequate. After bending, quench the part quick in water, like a blacksmith in a western movie. You can hold a small part under the faucet. That will restore the strength of the material.

More: Working Metals ...

Kitchen Table

Workshop - Miscellaneous

Comments on Kitchen Table

Submit a Comment

Working Metals